Versions Compared

Old Version 18

changes.mady.by.user Unknown User (jeroen.brackez@imec.be)

Saved on

compared with

New Version Current

changes.mady.by.user Axel Magdelijns

Saved on

Key

  • This line was added.
  • This line was removed.
  • Formatting was changed.

Table of Contents

Scope

This page contains the Kmehrmessages for testing the integration of connector, gateway and the SUT.

Instructions for EVS use

Warning

IMPORTANT: This test will use both the old (EVSEVSc) and the new (EVSgEVS) version of EVS.

The test will contain the export file with all the MSE transactions for that test.

...

The EVS parameter writeAsIs must be set to false.


Description

After reading the medication scheme, the results can be verified in the SUT.


S14W10: Reading and Writing with Connector and Gateway

Info

Which EVS version that has to be used for this test will depend on the SUT.

If the SUT writes with the Connector, EVSg EVS will have to be used.

If the SUT writes with the Gateway, EVS EVSc will have to be used.

If the SUT supports writing with both Gateway and Connector, this test can be performed twice in similar fashion to described above.

When using EVSgEVS, upload this EVS export file with EVS-action REPLACE.

When using EVSEVSc, upload this EVS export file with EVS-action REPLACE.

Reading

  1. Open the SUT and sync with Vitalink.

Expected Results(Reading)

  • TS-1: The SUT should be able to read the medicationscheme without problems.
  • TS-2: The patient print (and UI) should hold the same data as seen in the 'Verification Screenshot' below.
  • TS-3: The caretaker print (and UI) should hold the same data as seen in the 'Verification Screenshot' below.
  • TS-4: There is a medicationscheme with 4 medications.

Writing

  1. Make sure that the 'Reading' part of this test is performed first.
  2. Add a dot(.) in the 'instructionforpatient' field of each medication in the medicationscheme and then sync to Vitalink.

Expected Results(Writing)

  • TS-5: The alteration should have been written to Vitalink without causing errors or losing any data.
  • TS-6: The patient print (and UI) should hold the same data as seen in the 'Verification Screenshot' below, with the added dots(.) in the 'instructionforpatient' field.
  • TS-7: The caretaker print (and UI) should hold the same data as seen in the 'Verification Screenshot' below, with the added dots(.) in the 'instructionforpatient' field.
  • TS-8: There is a medicationscheme with 4 medications.

Verification screenshot